Motorola PM1200, Basic Service Manual

Page: 82 / 138

October 26, 2007 6880309U09-A
6-28 Disassembly/Reassembly Procedures : Replacement Procedures
10. Place the power wire assembly [37] to the terminal by using a CR-V PH2 torque driver, fasten
the 2 SEMS screws, HSM3x6 NI [17] to the main-unit board kit [13] as shown in Figure 6-50 .
(Torqued to 5.8–6.9 kgf*cm/ 5–6 in. lbs)
Figure 6-50. Connecting Power Wire Assembly to Main-Unit Board Kit
11. After installing the main-unit board kit, reassemble the front panel by following the steps
outlined in 6.2.3.1.2: “Transceiver Front Panel Reassembly” on page 6-16.
6.2.3.4 PA-Unit Board Kit Disassembly/Reassembly
NOTE: Bracketed numbers are identical to item numbers shown in Figure 9-2. “PM1200 Radio
Exploded View” on page 9-3 .
6.2.3.4.1 PA-Unit Board Kit Disassembly
1. Ensure all accessory connections, power, antenna, and microphone are unplugged.
2. Using a CR-V PH2 screwdriver, remove the 7 binding head screws, M3x6 SUS B [23] from
the top cover [24] as shown in Figure 6-51 . Save them for later use.
Figure 6-51. Removing Screws from Top Cover
1
2
2
5
1
6
7
3
4