Motorola PM1200, Basic Service Manual

Page: 71 / 138

6880309U09-A October 26, 2007
Disassembly/Reassembly Procedures : Replacement Procedures 6-17
4. Using a CR-V PH2 torque driver, fasten the 2 binding head screws M3x6 SUS [6] to the front
panel [4] as shown in Figure 6-29 . (Torqued to 3.5–4.6 kgf*cm/ 3–4 in. lbs).
Figure 6-29. Installing Front Panel Screws
5. Carefully lay the top of the radio facing downward on a clean, flat surface.
6. Using a CR-V PH2 torque driver, fasten the 2 binding head screws M3x6 SUS B [9] with
2 o-ring [10] to the front panel as shown in Figure 6-29 . (Torqued to 3.5–4.6 kgf*cm/
3–4 in. lbs).
Figure 6-30. Installing Bottom Screws to Front Panel
7. Lay the top of the radio facing upward.
8. Place the top cover [24] on the chassis [11] and seat it properly. Compress the cover and
chassis together to squeeze the foam [25] into place and to make torquing the screws easier.
1
2
1
2