Motorola PM1200, Basic Service Manual

Page: 58 / 138

October 26, 2007 6880309U09-A
6-4 Disassembly/Reassembly Procedures : Replacement Procedures
6.2.2.1.2 PM1200 Control Head Panel-Interface Unit Board Kit Disassembly
1. Carefully separate the foam [27] from the speakerphone jack at the panel-interface unit board
kit [25].
2. Using a CR-V PH2 screwdriver, remove the 2 binding head screws M3x8 SUS B [8] from the
front housing assembly [10].
3. Lay the bottom side of control head facing upward on a clean, flat surface.
4. Using a CR-V PH2 screwdriver, remove the 2 binding head screws M3x8 SUS B [8] with the 2
o-rings [9] from the front housing assembly [10].
5. Carefully separate the frame [28] from the front housing assembly [10].
6. Carefully disconnect the connection cable from the mating connector on the rear of display
unit board kit [22] as shown in Figure 6-4 .
NOTE: Be careful not to damage the mating connector while unplugging the connection
cable.
Figure 6-4. Removing Connection Cable (Display Unit Board Connector)