9-16
September 27, 2000
68P81093C75-O
Verifying Receiver
Circuitry Procedure
Step 1. Connect test equipment by performing Step 1 through
3 shown in Figure 7.
NOTE: The cover plate over the SCM side of the chassis
must be removed to perform these tests.
Step 2. Disable PL and carrier squelch by repeatedly pressing
the PL/CSQ/Off button until receiver noise is heard
through the handset (or external speaker). Refer to
Figure 5 for the location of the PL/CSQ/Off button. If
no audio is heard, suspect the following:
•
Faulty Receiver Module
•
Faulty Station Control Module
•
R2001 is outputting a carrier signal
Step 3. Set R2001 to generate a 0.5 µV (-13 dBm) FM signal
at the PDR 3500 receiver frequency, modulated by a 1
kHz tone at 3 kHz deviation. The 1 kHz tone should be
audible through the handset (or external speaker). If
no audio is heard, suspect the following:
•
Faulty Station Control Module (2.1 MHz
reference)
•
Faulty Receiver Module
•
Faulty antenna-to-Receiver preselector RF cable
•
Faulty R2001-to-station RF cable
•
Duplexer/station receive frequency mismatch, or
faulty duplexer
