Motorola MVME712A, Installation And Use Manual

Page: 19 / 80

2-2 Computer Group Literature Center Web Site
Preparing and Installing the Hardware
2
Preparing the MVME712M Module
The locations of the headers, LEDs, terminators, and connectors for the
MVME712M are shown in
Figure 2-1 . The module has been factory tested
and is shipped with factory-installed jumpers that configure the
MVME712M to provide the system functions required for a VMEbus
system.
The factory default configurations are shown in the following paragraphs
with descriptions of each header. The module is operational with the
factory-installed jumpers.
DTE/DCE configuration select headers
Serial ports 1 through 4 can be configured as a modem (DCE) for
connection to terminal or configured as a terminal (DTE) for connection to
modem. The MVME712M is shipped with the ports configured for DTE
operation.
The following table lists the serial ports with their corresponding jumper
headers.
Figures 2-2 through 2-9 illustrate the VME module and MVME712M
transition module with the interconnections and jumper settings for
DCE/DTE configuration on each serial port.
Table 2-1. Serial port jumpers/headers
Serial Port
Board
Connector
Panel Connector
Jumper Header
DCE/DTE
Port 1 J7 Serial port 1/ Console J1/J11
Port 2 J8 Serial port 2/ TTY J16/J17
Port 3 J9 Serial port 3 J13/J14
Port 4 J10 Serial port4 J18/J19