Pager Programming Guide
Minitor IV
Getting Started
Figure 3 Programmer Hardware Connections
Initializing Minitor IV for Programming
The Minitor IV must be initialized for programming prior to installation into the
programmer nest. Refer to Figure 4 and perform the following steps:
1. Turn the On/Off volume control to the Off (counterclockwise) position.
2. Set the function switch to position ‘C’.
3. With your right or left thumb, press down firmly and hold the reset button.
4. With your other hand, turn the volume control to On (clockwise).
5. The amber and red indicators should both light and a constant loud tone
should sound for three seconds.
6. Release the reset button as soon as the events in Step 5 occur.
7. Observe the position of the programming pins and insert the Minitor IV into
the programming nest. The red indicator on the programming interface
should light.
Figure 4 Controls and Indicator Location
4 9/20/2004
6880309M81-A