Getting Started
9
ENGLISH
4.
If there is no connection or you are out of range, the video display will go
Off and the Unit will beep every 5 seconds. Move the Parent Unit closer to
the Baby Unit until the link is re-established.
5.
Press and hold the
P
POWER ON/OFF button, until the progress bar
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon
turns RED to indicate that the battery is low, and will beep
every 16 seconds. Thus indicating the battery will need to be charged and will
take approximatively 12 hours.
When Charging
1.
When powering OFF, when the adapter is plugged in, the adapter logo will
display on screen followed by a flashing battery logo for 45 seconds.
2.
When powering ON, when adapter is plugged in, the battery icon on
screen's top right corner will show that the battery is charging.
2.3
Registration (Pairing)
The Baby Monitor is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedures
below:
1.
Press the
M
button of the Parent Unit and the menu bar will pop up.
2.
Press the
<
LEFT button or
>
RIGHT button until
is highlighted, and
the
del/add/view/scan
menu will pop up.
3.
Press the
+
UP button or
-
DOWN button to select
add
, then press the
OK
button to confirm.
4.
cam 1
/
cam 2
/
cam 3
/
cam 4
will pop up, press the
+
UP button or
-
DOWN
button to select the desired Camera and then press the
OK
button to start
searching for a Camera Unit.
5.
Press the
OK
button to confirm.
6.
Press and hold the PAIR button on side of the Baby Unit until the Parent Unit
finds the Camera, beeps and then the video from the Camera will appear.
NOTE
If a particular Baby Unit was registered previously, registering the current Baby
Unit will overwrite the old registration.