Getting Started
9
ENGLISH
2.3
Parent Unit Power Supply
IMPORTANT
Installing the rechargeable battery pack and charging it fully before use is
recommended. This will allow the unit to operate on battery in the event
of a power failure.
1.
Connect the small plug of the power adapter to the parent unit and
the other end to the electrical outlet. Only use the enclosed power
adapter (6V DC/500mA).
2.
Press and hold the
P
POWER ON/OFF button, until the progress
bar finishes scrolling, to turn ON the parent unit.
3.
Once the baby and parent units are switched on, the display on the
parent unit will show the video captured by the baby unit.
4.
If there is no connection or you are out of range, the video display
will go off and the words
No Signal
will be shown on the LCD display,
and the unit will beep every 5 seconds. Move the parent unit closer
to the baby unit until the link is re-established.
5.
Press and hold the
P
POWER ON/OFF button, until the progress
bar finishes scrolling, to turn OFF the parent unit.
NOTE
The battery icon
turns RED to indicate that the battery is low, the red
LED blinks, and it gives a beep every 16 seconds. The battery needs to
be recharged. The battery pack takes about 16 hours to charge fully.
When charging
1.
During power OFF, when the adapter is plugged in, a flashing battery
symbol will display for 45 sec. The Blue LED at the top left will flash to
indicate the adaptor is plugged in.
0
