10
Getting Started
2.4
Link
NOTE
Do not place the Baby unit or cables in the crib or within arm’s reach of the baby
(the unit should be at least 1 metre away).
When using the baby monitor for the first time, it is advised to test the
connection.
• Install the parent unit in the same room as the baby unit, but make sure there
is at least 1 metre between the 2 units.
• When both units are switched on, the parent unit will search for the baby
unit.
• The green link LED on the Parent unit will flash until the parent unit is
connected with the Baby unit. Once the link is established, the LED will stop
flashing.
• The sound captured by the microphone on the Baby unit will be audible on
the parent unit.
• The detected sound level is indicated by the LEDs on the front of the Parent
unit.
• When the connection is established, move the Parent unit to the room you
want to monitor from, but within the operational range.
• When there is no connection or the unit is out of range, the Parent unit emits
a warning beep every 20 seconds and the green link LED on the Parent unit
will flash.
• Move the Parent unit closer until the link is re-established.
2.5
Paging
If the parent unit is misplaced, press the
key on Baby unit. The Parent unit will
emit a repeated beep tone for 30 seconds so that you can locate it.
Press any key on the Parent unit, or the
again on the Baby unit, to stop paging.
