Motorola M68EML08EY, User Manual, Page: 17 / 36

General Information
Target Cable Assemblies
User’s Manual M68EML08EY Emulation Module - Version 1.0
MOTOROLA General Information 15
1.6 Target Cable Assemblies
To connect your EML08EY to a target system, you need the included target
cable and adapters. See Figure 1-2.
The cable assembly for a 32-pin thin quad flat pack (QFP) package consists of:
a flex cable, a target head adapter, a socket-saver and a QFP surface mount
adapter. One end of the target cable plugs onto EML08EY connectors J2 and
J3. The other end of the flex cable plugs onto the target head adapter, which
plugs onto the QFP surface mount adapter. You should solder the QFP surface
mount adapter directly onto the target-system board in place of the MCU. The
socket-saver goes between the target head adapter and surface mount adapter.
If you use it, it will reduce wear on the target head adapter. After many
insertions, you can replace the socket-saver without replacing the entire target
head adapter.
Table 1-2 lists target cable and head part numbers appropriate for the
EML08EY.
Figure 1-2 Target Cable Assembly
Table 1-2 EML08EY Target Cable and Head Assemblies
MCU Package
Flex Cable
Part Number
Target Head Adapter
Part Number
Surface Mount Adapter
Part Number
Socket-Saver
Part Number
32-pin QFP-FA M68CBL05C M68TC08EYFA32 M68TQP032SA1 M68TQS032SAG1