Motorola HH1620, User Manual

Page: 38 / 88

Configuration
If using a Static (Fixed) IP address, you need the
IP address and related information (Network
Mask, Gateway IP address, and DNS address)
IPoA (IP
over ATM) Normally, the connection
is "Always on". ADSL parameters (VPI and VCI) may be
required, if they cannot be detected
automatically.
IP Address allocated to you, and related
information, such as Network Mask, Gateway IP
address, and DNS address.
LAN Setup
Configure the DSL Router IP address and Subnet mask for LAN interface.
IP Address IP address for the HH1620, as seen from the local LAN. Use the default value
unless the address is already in use or your LAN is using a different IP
address range. In the latter case, enter an unused IP Address from within the
range used by your LAN.
Subnet Mask The default value 255.255.255.0 is standard for small (class "C") networks.
For other networks, use the Subnet Mask for the LAN segment to which the
IAD-200 / IAD-200W is attached (the same value as the PCs on that LAN
segment).
Enable UPnP
Enable IGMP
Snooping IGMP Snooping provides a dynamic user registration mechanism to decide
whether to multicast packets or not to the specific user in the specified group.
Enable/Disable
DHCP Server If Enabled, the HH1620 will allocate IP Addresses to PCs (DHCP
clients) on your LAN when they start up. The default (and
recommended) value is Enabled.
If you are already using a DHCP Server, this setting must be Disabled,
HH1620 Wireless VoIP Gateway
User’s Guide
31