GM350 Mobile Radio Connection Information
1-2
RSS Installation Manual
2.0
GM350 Mobile Radio Connection Information
To run the Radio Service Software (RSS), you will need the following equipment:
1.
IBM 386 DX 33 or equivalent with 8 MByte RAM, Hard Disk with 10MBytes free disk space and
3.5” Floppy Disk Drive.
2.
WIN 3.1
TM
, MSDOS
TM
5.0 or later.
3.
Radio Interface Box (RIB)
RLN4008B.
4.
RIB to Computer, cable
3080369B71 / 72.
5.
RIB power supply
EPN4040A / EPN4041A
(220 VAC) or 9V battery.
6.
Radio to RIB, Programming/Test cable
GTF374A
.
7.
Radio Power Supply
GPN6133A
or equivalent.
Figure 1-1
GM350 Radio Programming Setup.
2.1
Configuring the RIB and GM350 Radio
1.
Connect the RIB to the computer (Figure 1-1) using the interface cable 3080369B71 or 3080369B72
depending on the computer connection to Serial COM Port 1. If you are unsure of the connection on the
back of your computer or the COM port, then please consult the computer manuals.
2.
Plug the 25 pin end of the Radio programming cable, GTF374A into the RIB. Then plug the other end
into the MIC connector on the radio.
3.
Connect the RIB Power supply to the RIB and plug the other end into a wall outlet, (alternatively a 9V
battery may be used instead of the power supply).
4.
Connect the radio to a power source and press the On/Off button to turn the radio on.
Software
Computer
GM350
RLN4008B
Radio
3080369B71 Interface cable IBM XT 25pin
RIB to Computer Cable.
Plugs into RIB and computer.
Plugs between the RIB and
Std programming cable.
GPN6133A
GTF374A
15 PIN
25 PIN
Mobile Radio
EPN4040A PSU U.K. plug
EPN4041A EURO plug
3080369B72 Interface cable IBM AT 9pin
radio MIC connector.
GKN6266A
DC cable for base
operation or equivalent.
Interface
Box
RIB Power Supply
Note: 9V (PP9) Battery
can be used making
power supply optional.
Power Supply
User Manual
or equivalent
