Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 463 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Expanding to 4 Channel Cavity Combiner
Procedure 15-9 Configure Site Controller IDs (Continued)
5
If the IDs are the same, one of the ID values have to be changed. To do so, log onto the Site
Controller Application MMI.
It does not matter if it is the ID value of SC1 or SC2 that is changed, as long as they
do not have the same ID value.
6
From the SC: prompt, run the command
id x
where x can be either A or B. Make sure to de
fi
ne
a value different for the two Site Controllers.
7
Reset the Site Controller.
Expanding to 4 Channel Cavity Combiner
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
■
■
This section describes how to expand from a two-channel Cavity Combiner to a four-channel
Cavity Combiner. There are two types of Cavity Combiners for MTS 4 - Auto Tune Cavity
Combiner (ATCC) and Manual Tune Cavity Combiner (MTCC).
List of Equipment in the Expansion Kit
Order of an additional Cavity Combiner is dependent on the type of Cavity Combiner existing in the
current con
fi
guration of the MTS 4 Cabinet. It can be either of two types:
•
Auto Tune Cavity Combiner (ATCC)
•
Manual Tune Cavity Combiner (MTCC)
Figure 15-13 Example of an Auto Tuned Cavity Combiner
6802800U74-N September 2009
15-33