Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 231 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Base Radio Test Application Software Upgrade (optional)
Base Radio Test Application Software Upgrade (optional)
It is important to make sure that this procedure never is used to downgrade the Test Application.
Procedure 6-6 How to Upgrade to Latest Test Application Software
1
Point 3COM server to the folder containing the BRC Test App software.
2
Connect a RJ45 cable to the serial port of the PC and the Service port on the Base Radio.
3
Connect a crossed Ethernet cable to the PC and the SC1 port on BR
4
Reset BR and enter boot1 mode.
Do not enter testapp mode from here
5
Type
ferase 0x10100000 4M
and press
Enter
.
6
When prompt returns type
ifconfig eth0 address 10.0.253.<CAB><POS>
and
press
Enter
.
7
When prompt returns type
finstall testapp
/tftp/10.0.253.100/R064020ROM.srec
and press
Enter
.
R064020ROM.srec
in command above is used as an example. Please indicate
latest released
fi
le when entering command.
Result: BRC will reset itself at the end
8
Enter boot1 mode and then enter test app mode.
9
Login as factory user in test app mode, type
fv -oplatform
and press
Enter
.
On the last line of the output check that the version is R064020 or which ever version was
upgraded to in
step 7 .
10
Reset the BR by typing
reset -oplatform
and press
Enter
.
11
Disconnect the service cable from the BR and reconnect the Ethernet cable to LAN 1.
12
Rerun Procedure 6-5, "How to Verify the Base Radio Software Version Number," on page 6-22
to verify that the latest versions have been installed correctly.
Transmitter Verification
The transmitter veri
fi
cation procedure veri
fi
es the transmitter operation and the integrity of the transmit
path. This veri
fi
cation procedure is recommended after replacing the Base Radio module.
6802800U74-N September 2009
6-23