Motorola DIMETRA MTS 2, Installation, Configuration And Basic Service Manual

Page: 223 / 517

MTS 2 and MTS 4 Installation, Con
fi
guration and Basic Service Manual Selecting Base Radio Position and Receivers
Figure 6-4 BRC Indicators
Selecting Base Radio Position and Receivers
The new Base Radio needs to be assigned a position identi
fi
er and is performed from the Service port.
MMI commands are used to:
•
Set the position identi
fi
er of the Base Radio within the cabinet.
•
Set the number of active receivers (diversity) of the new Base Radio.
These operations are described in the following procedures. Use the MMI commands as outlined in the
“MTS Interface Commands” booklet for detailed information on using the MMI commands.
6802800U74-N September 2009
6-15