PCI Mezzanine Card Installation
http://www.motorola.com/computer/literature
1-13
1
PCI Mezzanine Card Installation
You can mount one +3.3V or Universal PCI Mezzanine Card (PMC) on
each PMC site of the CPIP5430, presuming a hard drive has not been
installed in PMC slot 2, either from the factory or by following the
procedure previously outlined in this document.
The board's PMC sites are keyed for a +3.3V PCI bus interface and will
not accept other PMCs with different voltage requirements. Removing the
key may be necessary when att3.3v or universal PMCs with
components that cover the key location (such as hard drive/controller
modules); removing the key DOES NOT CHANGE the bus voltage. To
install a PMC on a CPIP5430 that is currently installed in a chassis, refer
to the figure on page
and perform the following steps. If you are
installing a PMC on a board that has not yet been installed in a chassis,
begin with step 6.
Some devices, such as IDE connector components may restrict proper
seating of PMCs that populate the PMC1 site. If this occurs, do not attempt
to install a PMC on that site.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD
strap to the chassis as a ground. Keep the ESD secured throughout this
procedure.
2. Shut down the operating system.
3. Remove the chassis or system cover(s) as necessary.
4. Carefully remove the CPIP5430 from its slot and lay it flat, with
connectors J1 through J5 facing you.
5. Avoid touching areas of integrated circuitry. Electrostatic discharge
can damage these circuits.
6. Remove the PMC filler(s) from the front panel.
Note
The following illustration may not represent the exact board
you are using, it is meant for illustration purposes only.
7. From behind the front panel, slide the edge connector of the PMC
module into the PMC 1 front panel opening and place the PMC
