1-14
Computer Group Literature Center Web Site
Hardware Preparation and Installation
1
module on top of the base board. The four PMC connectors on the
underside of the PMC module should then connect smoothly with the
corresponding PMC connectors on the CPIP5430 and properly align
the PMC VIO keying pin.
8. Insert the four screws through the holes on the bottom side of the
CPIP5430 and tighten the screws.
9. Reinstall the CPIP5430 in its proper slot. Be sure the module is well
seated in the backplane connectors.
10. If necessary, connect the system to its AC or DC power source and turn
the power on.
Note
The rear I/O signals on the J6 pins of the PMC 1 slot are
routed to the J3 connector on the CPIP5430 baseboard.
Verify pin compatibility with the backplane prior to using.
4277 0404
