Motorola CPIP5430, Installation And Use Manual

Page: 21 / 138

Unpacking Guidelines
http://www.motorola.com/computer/literature 1-3
1
Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list
and verify that all items are present. Verify that the coin cell battery is in
its holder and inserted correctly. Save the packing material for storing and
reshipping of equipment.
Note If the shipping carton is damaged upon receipt, request that the
carrier’s agent be present during the unpacking and inspection of
the equipment.
!
Caution
Caution Avoid touching areas of integrated circuitry; static discharge can damage
circuits.
Use ESD
Wrist Strap
ESD Motorola strongly recommends that you use an antistatic wrist strap and a
conductive foam pad when installing or upgrading a system. Electronic
components, such as disk drives, computer boards, and memory modules
can be extremely sensitive to electrostatic discharge (ESD). After
removing the component from its protective wrapper or from the system,
place the component flat on a grounded, static-free surface (and, in the case
of a board, component side up). Do not slide the component over any
surface.
Install hard disk drive (if
required) 2.5-inch HDD Installation on page 1-11
Install PMC module (if required) PCI Mezzanine Card Installation on page
1-13
Install the CPIP5430 in the
chassis Installing a Board on page 1-15
Install transition module into
chassis (optional). Installing the RTM on page 5-7
Table 1-1. Startup Overview (continued)
What you need to do... Refer to...