Removing and Installing the Power Supplies
http://www.motorola.com/computer/literature
3-35
3
Removing and Installing the Power Supplies
This section tells you how to remove and reinstall the power supply
assembly in the CPX2108, CPX2208, and CPX2408 chassis.
!
Warning
Only properly trained service personnel should remove or
install power supplies. Do not touch bare parts inside the
enclosure because of the possible presence of hazardous
energy levels.
Removal of the power supply gives you access to high
voltages. Set the power switch to OFF (O). Set the power
supply switch(es) to OFF (O) where necessary. Disconnect all
power cords from their sources before working on the chassis.
Let the capacitors in the power supply discharge for one
minute.
Tools You Need
You need these tools to remove or install a power supply:
❏
a number 1, Phillips head screwdriver
❏
a number 1, Phillips head screwdriver (right angle)
Removing and Installing a Power Supply
Use this procedure to remove or install a power supply.
1. Set the main power switch to OFF (O).
2. Set the power supply switch(es) to OFF (O) where necessary.
!
Warning
Your system may have multiple power supply cords.
Disconnect all power supply cords before servicing.
Summary of Contents for CompactPCI CPX2000 Series
