Motorola CDR500, Programming Manual

Page: 63 / 104

March, 2001 6864110R66-O
8-3
CDR500 & CDR700 Repeater Service Manual Programming Professional Series Radios for use with a Basic Repeater Controller
Unidirectional Repeater
7. Click the “Ignition Sense Type:” dropdown
arrow button. Select “On/Off & Ignition”.
Your
screen should appear similar to
Figure 8-5.
8. Click the “Accessory Pins” tab.
9. Click the “Accessory Package” dropdown
arrow button. Select “RICK or I20R Tx”. Verify
that pin 3 is “External Mic PTT (Input)”,
Active Level “Low”. Your screen should
appear similar to Figure 8-6.
In order to realize a “transparent” operation (60% peak
system deviation from the transmit radio for 60% peak
system deviation on the received signal), the accessory
microphone gain for the transmit radio may be
increased.
10. Click the “Microphone” tab.
11. Click the up-arrow button next to the “Acces-
sory Mic Gain (dB)” display. Each click will
change the gain by 1.5 dB. For use with the
R*I*C*K, increase the gain to 31.5 dB or 33.0
dB. Your screen should appear similar to
Figure 8-7.
12. Close the “Radio Configuration” window.
13. Click the + indicator next to “Conventional
Personality” selection from the opening CPS
“Tree View” window.
14. Double click the “Conventional Personality -
1” selection.
15. Select the “Basic” tab.
16. If the radio is a display model (LCD front
panel), you may enter an “Alias” such as
“Repeater TX”.
17. Select a “Channel Bandwidth (kHz):” as
defined by the radio licensing authority.
Figure 8-5. Basic (R*I* C*K) Unidirectional
Repeater, Accessory Configuration, Transmit Radio
Figure 8-6. Basic (R*I*C*K) Unidirectional
Repeater, Accessory Pins, Transmit Radio
Figure 8-7. Radio Configuration, Microphone,
Transmit Radio