Motorola BSR 2000, Configuration And Management Manual

Page: 453 / 650

Release 1.0 Configuring Routing Policy
526360-001-00 Rev. B MGBI 8-15
Configuring a Policy-Based Route Map
You must identify or create a route map to use for policy-based routing to enable
policy-based routing. The route map specifies the match and set parameter and the
resulting action if all of these parameters are met. You can define additional route map
parameters to be used for policy-based routing. These parameters can be added to an
existing route map or included in a new route map. See
Creating a Route Map on page
8-2 for more information.
Defining Match Criteria
The following match commands can apply when configuring a policy-based route
map:
match ip address
match ip next-hop
match ip route-source
Refer to Using Match Statements to Define Routing Conditions on page 8-2 for more
information on defining a match criteria using these commands.
Defining the Route
Set commands are used to define a route in the route map to be used for policy-based
routing. If an interface or next-hop specified by these commands is unreachable, then
destination-based routing is used by default. You must specify at least one of the
following
set commands to define a route:
set interface
set ip next-hop
set default interface
set ip default next-hop
set ip diff-serv
Note: If no match parameters are specified in the route map, then all
incoming packets are considered for policy-based routing.