Motorola BSR 2000, Configuration And Management Manual

Page: 34 / 650

BSR 2000 Configuration and Management Guide Release 1.0
2-2 MGBI 526360-001-00 Rev. B
Using a Console Session to Access the CLI
This section describes accessing the CLI by connecting a terminal or PC with terminal
emulation software to the BSR’s console port. The BSR supports one CLI session
through its console port. Before connecting to the BSR through a console session, the
following prerequisites must be met:
■
The terminal application on the terminal or PC uses COM port 1 or 2.
■
A physical connection exists between the BSR and the terminal or PC.
■
The console settings for the terminal or PC are set as shown in Table 2-1 :
To start a console CLI session, do the following:
1. Connect to the BSR. The console session begins. The
MOT>
prompt displays.
2. Enter the enable command and press the Enter key.
MOT
>
enable <Enter>
A
Password:
prompt displays.
3. Enter the password and press the Enter key to access Privileged EXEC mode.
The
MOT
#
prompt displays.
For a detailed discussion of the different command line modes, refer to the CLI
Command Modes section.
Table 2-1 Console Settings
Console Parameter Setting
Baud Rate 9,600
Data Bits 8
Flow Control None
Parity None
Stop Bits 1