Motorola BSR 2000, Configuration And Management Manual

Page: 103 / 650

Release 1.0 Configuring the System
526360-001-00 Rev. B MGBI 3-53
timeout
1-1000
specifies a timeout value in seconds for this server.
The default value is 10.
Specifying a Global Encryption Key
Use the tacacs-server key command to specify a global encryption key for all
communication between clients and TACACS servers. A global
encryption key is used if no encryption key is specifically configured for this
server. Use the
tacacs-server key command, as follows:
MOT
(config)#
tacacs-server key <
WORD
>
where:
WORD
specifies an alphanumeric authentication and encryption key. This key
must match the key used by the server.
Specifying a Global Port Number
Use the tacacs-server port command to specify a global port number for all
communication between the server and the client. A global
port number is used if no port number is specifically configured for this
server. Use the
tacacs-server port command, as follows:
MOT
(config)#
tacacs-server port <
0-65536
>
where:
0-65536
specifies the global port number used for all communication between
clients and servers. The default port number is 49. If a
server is listening on any other port other than port 49, the port
number can be specified using this command.
Specifying a Global Retry Count
Use the tacacs-server retry command to change the global retry count which is the
number of times the client retries before moving on to the next configured
server. A global retry count is used if no retry count is specifically
configured for this server. Use the
tacacs-server retry command, as
follows:
Note: Specifying timeout or key parameters with the tacacs-server host
command overrides any global values entered with the tacacs-server key ,
tacacs-server retry , or tacacs-server timeout commands.