10
AP-6511E Access Point
•
Ensure the cable length from the Ethernet source (host) to the Power Injector and AP-6511E Access Point
does not exceed 100 meters (333 ft).
2.5 Wall Mount Installation
Ceiling mount requires holding the AP-6511E Access Point up against a T-bar of a suspended ceiling grid and
twisting the case onto the T-bar.
To install an AP-6511E model Access Point to a wall surface:
1.
Attach the metal mounting plate (shipped with the AP-6511E) to a wall surface at the desired deployment
location.
The screws used to mount the bracket are customer provided and should be #6, with a 2.00 inch length.
CAUTION
To avoid problematic performance and restarts, disable POE from a
wired controller port connected to an Access Point if mid-span
power
sourcing equipment
(PSE) is used between the two, regardless of the
manufacturer.
CAUTION
Ensure AC power is supplied to the Power Injector using an AC cable
with an appropriate ground connection approved for the country of
operation.
NOTE
Motorola Solutions recommends the following customer supplied
mounting accessories an AP-6511E wall mount installation:
2, screws, #6 x 2.00 inch pan head
2, wall anchors suitable for the #6 screws
!
!
Summary of Contents for AP-6511E
