Motorola AP-650 Series, Installation Manual, Page: 13 / 40

Installation Guide 13
• Two wall anchors
• Safety wire (recommended) and security cable (optional)
2.6.2 Wall Mount Procedure
1. Orient the case on the wall by its width or length.
2. Using the arrows on one edge of the case as guides, move the edge to the midline of the mounting area and
mark points on the midline for the screws.
3. At each point, drill a hole in the wall, insert an anchor, screw into the anchor the wall mounting screw and
stop when there is 1mm between the screw head and the wall.
NOTE
In the event that the original mounting screws are lost, the following
screws can be used instead: (ANSI Standard) #6-18 X 0.875in. Type A or
AB Self-Tapping Screw, or (ANSI Standard Metric) M3.5 X 0.6 X 20mm
Type D Self-Tapping Screw.
NOTE
When pre-drilling a hole the recommended hole size is 2.8mm (0.11in.) if
the screws are going directly into the wall and 6mm (0.23in.) if the
provided wall anchors are being used.