S P E C T R U M E n t e r p r i s e M a n a g e r
M o t o r o l a V a n g u a r d D e v i c e s
76 of 95
Call Statistics View
Access: In the X.25 Configuration Table, click the Calling
Table button.
This view contains a table that provides call
statistics for each of the device’s X.25 ports.
Column headings are as follows:
PortNo
Identifies a particular X.25 port.
Destn
All calls entering this port will be routed to any
destination specified in this column, irrespective
of route selection table entries.
PortAddr
For X.25 links with the REGO or REGI option
selected, this address is inserted into the calling
address field of the outbound or inbound call
packet. For MUX links the subaddress of the
channel is appended to this address and inserted
into the calling address field of the call packet.
IdleTime
The time in seconds that the port must be idle (no
calls) before being automatically disconnected. A
value of zero disables the Idle Disconnect feature.
This feature may only be enabled on
DIMO/DIMOa/DIMOb/DIMOv/SIMPv ports with
the BKUP option selected.
Security
For V.25bis backup ports, the type of call security
to use prior to the link being detected up: if value
is “disable,” both incoming and outgoing calls are
allowed; if “enable,” only outgoing calls are
allowed and incoming calls will be immediately
terminated. This parameter is only used with Link
Backup.
Protection
The level of data or connection protection
specified for calls to or from this port (the actual
level will be negotiated to the lesser of this level
and the level configured for the other end of the
call) : none = no protection; cpOnly = Connection
protection only; fullDcp = Full data and
connection protection.
DCPTimeout
The number of seconds that DCP on the
originating side will wait between reconnection
attempts.
DCPRetry
The number of times that DCP on the originating
side will attempt to reconnect before clearing the
call.
