Motorola 56F827, Hardware User Manual

Page: 22 / 56

2-6 56F827 Evaluation Module Hardware User’s Manual MOTOROLA
2.5 Clock Source
The 56F827EVM uses a 4.00MHz crystal, Y1, connected to its External Crystal Inputs,
EXTAL and XTAL. The 56F827 uses its internal PLL to multiply the input frequency by
20, achieving its 80MHz maximum operating frequency. An external oscillator source can
be connected to the hybrid controller by using the oscillator bypass connectors, JG4 and
JG5; see
Figure 2-4
. If the input frequency is above 4MHz, then the EXTAL input should
be jumpered to ground by adding a jumper between JG4 pins 2 and 3. The input frequency
would then be injected on JG5’s pin 2. If the hybrid controller needs to be synchronized to
the codec’s sample frequency, then the controller’s input frequency should be jumpered
using the 12.2280MHz codec frequency. If the input frequency is below 4MHz, then the
input frequency can be injected on JG4’s pin 2.
Figure 2-4. Schematic Diagram of the Clock Interface
2.6 Operating Mode
The 56F827EVM provides a boot-up MODE selection jumper, JG6. This jumper is used
to select the operating mode of the hybrid controller as it exits RESET. Refer to the
DSP56F827 User’s Manual for a complete description of the chip’s operating modes.
Table 2-3
shows the two operation modes available on the 56F827.
Table 2-3. Operating Mode Selection
Operating Mode JG6 Comment
0 1–2 Bootstrap from internal memory
3 No Jumper Bootstrap from external memory
56F827
EXTERNAL
OSCILLATOR
HEADERS
JG4
3
2
1
1
2
3
EXTAL
XTAL
JG5
10M
4.00MHz
12.2880MHz
F
re
e
sc
a
le
S
e
m
ic
o
n
d
u
c
to
r,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
n
c
.
..