Motorola solutions MCC 7100 IP, Setup And User Manual

Page: 52 / 170

2
Connect the Ethernet network cable between the dispatch console computer and the ASTRO
®
25 RNI network.
3 In the Control Panel , navigate to the Network and Sharing Center pane.
4 From the left-hand menu, select Change adapter settings .
5
If the
Local Area Connection
is disabled, right-click it. Select
Enable
.
6
Right-click
Local Area Connection
. Select
Properties
.
7 In the Local Area Connection Properties window, under the Connect using field, click
Configure
.
8 In the Network Connection Properties window, select the Advanced tab.
9 From the Property list, select Link Speed & Duplex .
10
From the
Value
drop-down list, select
100 Mbps Full Duplex
. Click
OK
.
11 Right-click Local Area Connection . Select Properties .
12 Double-click Internet Protocol (TCP/IPv4) and perform the following actions:
IMPORTANT:
Do not use (TCP/IPv6) to configure Internet protocols.
a In the General tab, select the Use the Following IP address option.
b In the IP address , Subnet mask and Default gateway fields, enter values provided for this
network interface card.
c
Select the
Use the following DNS server addresses:
option.
d Click Advanced .
e In the Advanced TCP/IP Settings window, select the DNS tab.
f
Under the
DNS server addresses in order of use
list, click
Add
.
g
In the
TCP/IP DNS Server
window, enter the DNS server address. Click
Add
.
h Repeat step 12 f and step 12 g for each DNS server in the order of use.
i
Select the
Append these DNS suffixes (in order):
option.
j
Under the list of DNS suffixes, click
Add
.
k In the TCP/IP Domain Suffix window, enter the domain suffix. Click Add .
l Verify that Register this connection's addresses in DNS check box is checked.
m
In the
WINS
tab, verify that the
Enable LMHOSTS lookup
check box is
not
checked.
n
On all subsequent windows, click
OK
.
o When prompted to reboot, click No .
13
Connect a network interface cable to the NIC.
Installing the MCC 7100 IP Dispatch Console Software
Perform this procedure to manually install a new instance of the MCC 7100 IP Dispatch Console
software or upgrade from the previous version of the software.
Prerequisites:
Ensure that you meet the following requirements:
• The Windows computer or workstation on which you want to install the software is running Windows
7 Professional with an approved service pack.
MN000672A01-E
Chapter 2: MCC 7100 IP Dispatch Console Setup and Installation
52 Send Feedback