4A
4B
B
A
B
A
A
B
C
D
E
52mm
70mm
48mm
48mm
35mm
52mm
60mm
48mm
3A
3B
EN
EN
03. INSTALLATION
LIMIT SWITCHES
Before you start to tune the limit switches, confirm the orientation of your engine tuning arrows.
This may have one or two possible orientations on the same motor: arrows going in or out. In
any position, the adjustment A rotates the tube from the top to the bottom and the adjustment
B rotates from the upwards. Any of the adjustments could be opening or closing depending on
the winding of the canvas (indoor or outdoor winding).
The canvas can wrap through the interior or the exterior side.
The direction will determine whether opening / closing is tuned in A or B.
B
A
POSITION 1
ARROWS INWARDS
Adjustment
A
Adjustment
B
Adjustment
B
Adjustment
A
ATTENTION:
All information given on this page is compatible with engines fitted with the
head on the left side. If you want to install on the right side, turn the information.
•
WINDING
POSITION 2
ARROWS OUTWARDS
B
A
Interior:
Adjustment A - Opening
Adjustment B - Closing
Exterior:
Adjustment A - Closing
Adjustment B - Opening
03. INSTALLATION
PLACING THE MOTOR ON THE WALL
Tubular Standard Motors
Ø
45mm Tubular Standard Motors
with compact fixation
Ø
92mm Tubular Motors
01
•
Place the fixing accessory on the wall and mark the holes to fix it.
02
•
Drill the holes and apply adapter sleeves for the screws to be used.
03
• Secure the accessory on the wall. For Ø92mm TUB, fix the motor directly because it
doesn't need accessory.
04
• Apply the motor on the accessory. When using C or D accessories, use a pin to hold it.
A
•
Plate for fixing all the TUB20 e TUB20E FRA motors.
B
•
Plate for fixing Ø45mm compact motors.
C
•
Plate for fixing Ø35mm and Ø45mm, Standard and MT (handle) motors
.
D
•
Plate for fixing Ø59mm Standard motors
.
E
•
Plate for fixing the motors with a Ø45mm compact fixation
.
Tubular MT Motors
