15A
15B
EN
EN
05. CONFIGURATION THROUGH SMS
05. CONFIGURATION THROUGH SMS
CONFIGURE RELAYS
RESTRICT RELAY 1 BY CALL
FEEDBACK NOTIFICATIONS
The following table shows the values to enable feedback notifications.
By default the notification value for all contacts is 000000
(no notification type is active).
Function
Send Message
Device Response
Check Impulse Time
9999 R1.G.T
MOTORLINE R1 G T 1
Function
Send Message
Device Response
Check Contact for
Feedback
9999 F1.G.P
MOTORLINE F1 G P (0/91XXXXXXX)
NOTE:
The
Relay Mode and Impulse Time
settings are done in the same way for both
Relay outputs. You only have to toggle the command between
R1
(Relay1) and
R2
(Re-
lay2) depending on the output you want to configure.
CONFIGURE CONTACTS FOR FEEDBACK
The M175 allows you to set up to four phone contacts so that feedback notifications
(SMS) can be sent on unrequest events.
RELAY MODE
IMPULSE TIME
The Relays can operate in two different ways: Monostable and Bistable.
Monostable Mode:
The device turns off at the end of the Set Pulse Time if there is no contact.
Bistable Mode:
The device remains on / off until a new command is available.
VALUE
DESCRIPTION
0
Monostable Mode
1
Biestable Mode
Function
Send Message
Device Response
Check Relay Mode
9999 R1.G.M
MOTORLINE R1 G M 0
The impulse time of the relays can be set and has a range of values from a minimum of
1 second
to a maximum of
240 seconds
.
The default impulse time is 1 second.
There is the possibility of set Relay 1 to be commanded by
Call
only.
The configuration values for this function are:
0:
Relay Control by Call, Bluetooth and SMS.
1:
Relay control by Call only.
Factory setting:
(
0) Call, SMS & Bluetooth
Function
Send Message
Device Response
See Relay Commands
9999 R1.G.B
MOTORLINE R1 G B 0
Enable Bistable Mode
9999 R1.S.M
?
MOTORLINE R1 S M 1
Reset Monostable
Mode
9999 R1.R.M
?
MOTORLINE R1 R M 0
(in these functions you shoulde put "?" at the end of the message you send if you want to receive a reply)
Enable Impulse Time
9999 R1.S.T 120
?
MOTORLINE R1 S T 120
Disable Impulse Time
9999 R1.R.T
?
MOTORLINE R1 R T 1
(in these functions you shoulde put "?" at the end of the message you send if you want to receive a reply)
Enable Restriction
9999 R1.S.B
?
MOTORLINE R1 S B 1
Disable Restriction
9999 R1.R.B
?
MOTORLINE R1 R B 0
(in these functions you shoulde put "?" at the end of the message you send if you want to receive a reply)
Set contact for
Feedback
9999 F2.S.P 92XXXXXXX
?
MOTORLINE F2 S P 92XXXXXXX
Delete contact for
Feedback
9999 F3.R.P
?
MOTORLINE F3 R P 0
(in these functions you shoulde put "?" at the end of the message you send if you want to receive a reply)