Motorline professional FLAMA, User'S And Installer'S Manual

Page: 9 / 15

C B A
1
3
3
2
2
8A 8B
EN EN
04. INSTALLATION
FIXING THE SAFE PROFILE
In order to the FLAMA work correctly, before the installation it is important to
take into account the following parameters:
• Read all the steps at least once, in order to learn about the installation and configuration
process.
• Check the horizontal ground alignment, so that the door can be installed properly.
• Make sure there is adequate electrical protection against short circuits / power surges and
grounding in Electrical Board.
• Be careful in the event of handling directly the control board. Improper handling can damage
some electrical components.
• Make sure you have prepared all the necessary materials for the installation.
• Evaluate the security devices to be installed. This will ensure that unexpected accidents do
not happen.
• Use appropriate screws to the place where the components of the FLAMA will be fixed.
• Do not use plastic wall plugs in the FLAMA installation.
04. INSTALLATION
PRE-INSTALLATION INFORMATION
CONTROL BOARD
It is very important that all precautions are respected!
Only in this way it can be assured the proper functioning and durability of the
FLAMA!
Before proceeding with installation, should check that if all the measurements are correct,
taking into account the installation location. It is also important that the installation site
is properly leveled, since only then will it be possible to ensure the correct operation of
the FLAMA.
PASS
AGE SP
AN
POSITION SAFE PROFILE
Apply the safe to the wall of the
installation place, paying attention to
the horizontal leveling.
The safe should be centered with the
span.
Based on the holes in the support plates,
mark the drilling areas.
FIX SAFE PROFILE
Drill the holes at the marked locations,
and then apply the safe to the wall,
fixing it with metal wall plugs or screws.
The safe must be securely fastened to
prevent accidents.
POSITION GUIDES
Place the guides at the installation place
to understand if the safe will be fixed in
the right place for the legs assembly.
1
3
2
METAL WALL
PLUGS OR
SCREWS
LED Status Description
A
(Green)
On 230V power supply
Off No 230V power supply
B
(Yellow)
On The battery is active
Off The battery has no charge
Flashing Motor without sinal
C
(Red)
On The battery is off
Off The battery is on
Control board reset button