headline bars
tabs
con
tinuation tabs
notes
war
nings
headline bars
tabs
continuation tabs
notes
warnings
headline bars
tabs
con
tinua
tion tabs
not
es
w
ar
nings
headline bars
tabs
continuation tabs
notes
warnings
model no. 011-1977-4
| contact us 1-888-942-6686
12
headline bars
tabs
continuation tabs
notes
warnings
headline bars
tabs
continuation tabs
notes
warnings
NOTE:
If you have charged the battery and it still will not start your car, do not use the Engine Start feature, or it could
damage the vehicle’s electrical system. Have the battery checked.
If the engine does turn over but never starts, there is not a problem with the starting system; there is a problem
somewhere else with the vehicle. STOP cranking the engine until the other problem has been diagnosed and corrected.
OPERA
TION
USING THE ENGINE START FEATURE
Your battery charger can be used to jump start
your car if the battery is low. Follow all safety
instructions and precautions for charging your
battery. Wear complete eye protection and
protective clothing.
1.
With the charger unplugged from the AC outlet,
connect the charger to the battery following the
instructions given in Battery in Vehicle section.
2.
Connect the charger to a live grounded 120 V
AC outlet.
3.
With the charger plugged in and connected
to the battery and chassis, press the Rate
Selection button until the Engine Start LED is lit,
and then press the Start button.
4.
Crank the engine until it starts or 5 seconds
pass. If the engine does not start, repeat. Do not
crank during the cool down period (see below).
This allows the charger and battery to cool
down.
NOTE:
During extremely cold weather, or
if the battery is under 2 V, charge the battery for
5 minutes before cranking the engine.
5.
If the engine fails to start, charge the battery for
5 more minutes before attempting to crank the
engine again.
6.
After the engine starts, unplug the AC power
cord before disconnecting the battery clamps
from the vehicle.
7.
Clean and store the charger in a dry location.
ENGINE STARTING NOTES
During the starting sequence listed above, the
charger is set to one of four states:
• Wait for ready –
The charger charges the
battery for 2 minutes before the Wait for
Cranking state. While waiting for ready,
the engine can be cranked. For severely
discharged batteries, it is not recommended
to crank during this time.
• Wait for cranking –
The charger waits until
the engine is actually being cranked before
delivering the amps for engine start.
• Cranking –
When cranking is detected, the
charger will automatically deliver up to its
maximum output as required by the starting
system for up to 5 seconds.
• Cool Down –
After repeated cranking during
a 3-minute ready period, the charger enters a
mandatory 3-minute (180-second) cool down
state. After 2 hours of Engine Starting, the
unit will automatically exit from the Engine
Start mode, just as if the Stop button had
been pressed; the Charging LED will not be
lit. During this time, the Engine Start LED will
blink to indicate the Engine Start operation is
temporarily paused.
WARNING!
Using the Engine Start feature WITHOUT a battery installed in the vehicle could cause damage
to the vehicle’s electrical system.
FPO
