Australian owned
Australian designed
Motolux is a world-class manufacturer of motorisation products and systems dedicated to window covering markets
worldwide. A designer and manufacturer of a fully integrated range of motorisation solutions, Motolux products are
suitable for commercial or residential use. Our high quality product range is streamlined to simplify the process of
manufacturing, installation and ongoing maintenance of almost any type of motorised window covering product.
61 (0)3 9876 0400
[email protected]
www.motolux.com.au
Ordering Information
Australia / New Zealand
PROGRAMMING INSTRUCTIONS 2/3
*Please make sure you hang the curtain before attempting to set limits.
Run the Curtain Track in both directions via the remote control, when the master carrier reaches either end of the track, that
End Limit is automatically stored.
You may have to fine adjust each limit to suit your own preferences.
This sequence needs to be done with no more than 20 seconds between commands otherwise the motor will exit
limit setting mode.
You Can “Fine Adjust” either end limit by:
Method 1
Method 2
Limit Setting
Fine Adjustment of Limits
1.
Go to the limit that you would like to adjust.
2.
Push and
hold
the
PROGRAM button
on the
remote control
until the
BLUE light
on the motor flashes 3 times.
3.
Using the
UP and DOWN buttons
on the remote control, move the master carrier to the position where you would like
the curtain to stop.
4.
Now push and hold the
PROGRAM button
on the
remote control
until the
BLUE light
on the motor flashes 3 times,
indicating the limits have been adjusted.
Test the Curtain.
Resetting a Motor Back to Factory
To Delete a Channel or a Remote
1.
Should you need to reset a motor back to Factory Settings you will need to push and
hold
the
PROGRAM button on the
bottom of the motor
for approximately 3 seconds. The light on the motor will
flash RED
.
2.
Within 10 seconds push and
hold
the
PROGRAMMING button on the bottom of the motor
for a second time. The light
will
stop flashing RED
and will
flash BLUE
3 times, indicating that the motor has been returned to Factory Settings and has
deleted all channels and limits.
1.
On the programmed Remote Control or Channel, push and
hold
the
STOP button until the RED light on the motor
starts flashing slowly.
2.
Within 10 seconds, push and
hold
the
PROGRAMMING button on the back of the remote control for approximately 7
seconds
. The
RED
light will go out, indicating the motor has been returned to Factory Settings.
1.
Should you need to delete a channel or a remote control from the motor, press and
hold
the
STOP button
for
approximately
5 seconds
. The light on the motor will slowly flash
RED
.
2.
Press and
hold
the
DOWN button
on the remote. The
BLUE
light will flash 3 times, indicating the channel or remote has
been deleted.
REVISION 2 - 2020
Curtain Motor 1.5Nm 240V AC Hybrid Power - 592130000 (MR68-1.5/100-EM-P)
