Motoalliance VIPER MA11922 Install Instructions Manual Download Page 5

Page: 5 / 8

MA11922

23001 Industrial Blvd

VIPER Yamaha YXZ Winch Mount

Rogers, MN 55374

866.527.7637

Place the remaining 5/16” bolts and the MA11922-2 Spacers into the MA11922-3 Fairlead Mount Plate as
shown in Figure 1 and Figure 6.

Figure 6

6. Lift the Fairlead Plate and hardware up into place. The four bolts will align with four holes on the front of the

frame.

Note:

If possible, have a helper for this section to help hold the plate and hardware in place while

it is being secured. If a helper is unavailable, use clamps or tape to hold the bracket and
hardware into place while you work.

Figure 7

Summary of Contents for VIPER MA11922

Page 2: ...cluded in your package Kit Contents Item Description QTY 1 MA11922 1 Main Mount Plate 1 2 MA11922 3 Fairlead Plate 1 3 MA11922 2 Spacer 2 4 5 16 18 x 2 5 Serrate Flange Bolt 2 5 5 16 18 x1 25 Serrated Flange Bolt 2 6 5 16 18 Serrated Flange Nut 2 7 3 8 16 Serrate Flange Nut 2 8 3 8 16 x 1 Serrated Flange Bolt 2 9 5 16 18 Hex Nut 4 10 5 16 18 x 1 Serrate Flange Bolt 2 Figure 1 ...

Page 3: ...alliance com 1 Remove the front center plastics Note It may be easier to remove the entire front hood but it is not necessary if you are just doing the winch install Figure 2 2 Put the MA11922 1 Main Mount Plate through the opening and down into place Rotate the mount 90 degrees to fit it through the opening Figure 3 ...

Page 4: ...rated Flange Bolts and Nuts to secure the bottom of the mount to the frame and use the 5 16 x1 Serrated Flange Bolts and Nuts to secure the top of the mount to the frame Verify that the mount is sitting flush to the frame and tighten down all hardware Figure 4 4 Install the fairlead that came with your winch to the MA11922 3 Fairlead Plate Figure 5 ...

Page 7: ...ce com Note for most people it will be very difficult to fit your fingers into the frame Tape the nut to a tool or a bolt or a small piece of scrap wood and use the tool to slide it up into place As shown in Figure 10 Figure 10 9 Verify that the Fairlead Mount Plate is square with your machine and tighten down at this time ...