MOTIVE-RC
MOTIVE-RC
2. Setting Telemetry on FrSky TARANIS with R8SB Receiver
Connect RX channel of receiver to UART TX port of FC
In the GUI PORTS tab, select the UART that corresponds to the telemetry (usually UART6 in F7 flight controllers)
Select FrSky in Telemetry. Leave the baudrate to AUTO.
The FC will reboot, applying the change.
Make sure you
’
re getting the telemetry values in Transmitter correctly.
3.
A1&A2 for battery voltage sensor
A1 and A2 are the analog telemetry ports on the R8SB receiver. A1 for internal receiver battery voltage sensor, A2
for external battery voltage sensor(0~36.3V,1~6S liPo)
How to use A2 port for external battery
Connect the battery to the A2 port of the R8SB receiver, set Taranis in
“
Telemetry
”
screen, select
“
Discover new
sensor
”
, you will find
“
A2
”
data.
We need to setup the A2 Ratio. Select A2, long press the ENT button to enter the setting interface.
The receiver’s maximum input voltage used for telemetry is 3.3V. Internal voltage divider is 11:1. Maximum voltage
reading for A2 is 3.3×11=36.3. We suggest to use 36.5V as this is recommended. Now you can get the correct
voltage of the battery on transmitter.
Declaimer: This receiver is RC compatible receiver with FrSky D8 Mode system. iRange X, Jumper, and FrSky are trade marks.
For technical support please mail to [email protected]
