motium MLC-1010, User Manual

Page: 7 / 41

User Manual Rev 1.0 7
1. Safety instructions
To prevent damage to the product and to ensure your own personal safety, please read
this
safety instructions chapter before handling the product.
•
There are no user serviceable parts inside the monitor. Only qualified,
experienced, and authorised electronics service personnel should access the
interior of the unit.
WARNING
High voltages are present inside the enclosure when power is connected to
the monitor. Turn off system power and disconnect the power cable from its
source before removing the rear panel. Turning the monitor off (via the Power
On/Off button) does not remove power to all internal components.
CAUTION
Do not attempt to service the monitor yourself.
Follow installation and troubleshooting instructions closely.
1.1. Notices and warnings
Please pay attention to the following:
1. Read these instructions carefully and keep this user's manual for later reference.
2. When cleaning, do not use liquid or spray detergents. Use a damp cloth.
3. Dropping the monitor, or letting it fall, could cause damage, and void the warranty.
4. Make sure the voltage of the power source is correct before connecting power to the
monitor.
5. Position the monitor’s Power and Signal Cable so that people cannot step or trip on it.
Make sure the cable is not under strain (i.e., has some slack) when it is connected.
6. All cautions and warnings on the monitor should be noted.
7. Never pour any liquid into an opening. This could cause fire or electrical shock.
8. Never open the monitor. For safety reasons, only qualified service personnel should
open the monitor.
9. If any of the following situations arise, get the unit checked by service personnel:
•
The Monitor Power and Signal Cable is damaged.
•
Liquid has penetrated into the monitor.
•
The monitor has been submerged in water for longer than 15 minutes.
•
The monitor does not work well, or you cannot get it to work according to the
user’s manual.
•
The monitor has been dropped and damaged.
•
The monitor has obvious signs of breakage or tampering.
10. Do NOT leave the monitor in an environment where the storage temperature is below
-20°C (-4°F) or above 80°C (176°F), as damage may result.