Low down the speed
If you feel it flying too fast in leaning period, you can
install this part to low down the flying speed.
Cut off the joints between flap and wing.
2
3
Install the flap adjustor on the joints of flat and wing,
then use glue to fix.
When install the adjustor, make sure it's aligned with
the top surface of wing and bottom surface of flap.
Binding
Turn on the transmitter,then connect the power of
receiver keeping the receiver BIND button till the light
turn on GREEN which means the binding is successful.
After that.it's unnecessary to bind again.
CAUTION: make sure the RX and TX is within one
meter,and around 10 meters no aimilar device.
If the light flashing,showing the binding failure. please
do again as above indication.
Motor Service
1.Thread motor wires through the holes under motor
and into fuselage.
2.lnstall motor onto motor mount, and use screws to fix.
Servo Service
Tail Servo Service
Use screws to fix servos onto the servo mount inside
fuselage. Make sure the servo wires are correctly
oriented as picture shown.
Wing Servo Service
�
---
-
-
-
�
-
-
�r;-
-�---
Take out the foam pieces from the flap servo slots .
7
