TABLE OF CONTENTS
Introduction and Safety Warning
1 Binding the Receiver
3
What’s Inside
1 Control Direction and Potential Channel Reversing 3
Product Overview
1 Setting Expectations: Flight Character and Flying Tips 3
Table of Contents
2 Pre-Flight Inspection and CG Balance
4
Specifications
2 Your First Flight
5
Unboxing and Inspection
2 Post-Flight Inspection
5
Basic Assembly
2 Troubleshooting
5
Radio Setup
3 Scale Accessories and Waterslide Decals
5
Program a Throttle Cut Switch
3 Maintenance Schedule
6
Program Dual Rates and Expo
3 Conclusion
6
Program Dual Rates and Expo
3
SPECIFICATIONS
Motor: Brushless
450L 3035-1800kV (6s 25.2V)
ESC:
4
0A with XT60 Connector
Cyclic Servos:
EMAX ES09MD Metal Gear Digital
Tail Servo:
EMAX ES9258 Metal Gear Digital
Main Rotor Blades:
Carbon Fiber, 325mm length
Flight Controller:
Required
(see
www.motionrc.com
f
or recommendations)
Flight Battery:
Required
(6s 1100mAh)
Radio Transmitter:
Required
Receiver:
Required
UNBOXING AND INSPECTION
Immediately inspect the outer shipping box for any damage. Also inspect the interior for any damage, either to the
box supports or the model itself. If any damage is present, do not continue unpacking the model. Instead, please
contact Motion RC Customer Support at
If the box and packaging are undamaged, continue unpacking the model itself. Remove the bubble wrap and
inspect the model for physical damage to the fiberglass, landing gear, and other external areas. If you find any
damage or the model does not meet your preference for workmanship, please contact Motion RC Customer
Support at
BASIC ASSEMBLY
Your RotorScale 450 PNP Helicopter was test flown at the factory. The blades included in the box are the exact
blades that were balanced and flown with your specific helicopter, and then were removed before packaging to
reduce the risk of damage during transport. For safety, do not install the main rotor blades until after the Radio
Setup has been completed.
You may apply the included waterslide decals and optional scale accessories before or after Radio Setup. See the
“Scale Accessories and Waterslide Decals” section in this Manual for further details.
