www.motionrc.com
Motion RC Supplemental Guide for the Detrum GAVIN-6A Transmitter
Page 2
4.
Control sticks—control the channel to which they are connected.
5.
CH5 switch—a two-position switch that is usually used for retracts.
6.
CH6 switch—a three-position switch that is usually used for flaps.
7.
SERVO REVERSING switches—control direction of servos connected to channels 1-4.
8.
RATE switch—activates HI (maximum range of motion) or LO (70% of range of
motion) rates.
9.
MIX switch—sets the configuration of the plane being controlled (standard, elevons, or
v-tail).
Power the Transmitter
1.
Remove the battery cover from the back of the transmitter.
2.
Install four AA batteries per the diagram in the battery well.
3.
Replace the battery cover.
4.
Push the power switch on (up). The transmitter turns on and you see the charge level of
the batteries indicated by the number of lights that illuminate.
5.
Push the power switch down to turn the transmitter off.
Calibrate the Transmitter
1.
Ensure that the throttle stick is in its lowest position (all the way toward the bottom of the
transmitter).
2.
Push and hold the trim button under the right stick all the way to the right and turn the