WIRING INSTRUCTION
Plugging the 5 cores socket ① of cycle computer controller into the 5 cores plug ③ of
cycle computer extensive cable.
Plugging the 5 cores plug ② connector of cycle computer display into the 5 cores
socket ④ of cycle computer extensive cable.
5 cores socket of
cycle computer controller
5 cores socket
of cycle computer display
5 cores socket of
cycle computer extensive cable
5 cores plug of
cycle computer extensive cable
①
③
②
④
① ④ cross section of 5
cores socket
② ③ cross section of 5
cores plug
* When connecting the wire, please align the cross-section gap between socket and plug.
INSTALLATION INSTRUCTION
Step 1:
Fixing CS500 cycle computer controller to the left handle bar and CS500 display to the
middle of handle bar, and adjusting them to the proper position and viewing angle.
Step 2:
Following the below picture to install the screw, and suggesting to use 2N.m - 2.5N.m
torque to tighten. ( Instrument damaged by over-locking is not promised to get
warranty service.)
Front wheel direction
5-M4×10
Locking torque: 2～2.5N·m
