mothercare Nixi Pushchair User Manual Download Page 7

Page: 7 / 10

3. Using your pushchair as an infant pram, continued

Birth to 9kg (or until your child can sit unaided)

4. Using your pushchair with an infant carrier

Birth to 13kg (approx. 1 year)

Ensure that the left hand and right
hand adaptors are used on the
correct side of the child seat.
To fit the adaptor to the child seat
squeeze the lever and insert into the
space below the handle

(dia 11a)

Make sure it is fully fitted and release
the lever to lock into place. Repeat this
process for both adaptors.

Fitting the infant carrier

First engage the brake. Unfold the armrest pads

(dia 14a)

Lower the infant carrier (labelled Type ‘A’) onto the armrests in the
orientation shown

(dia 11b)

, making sure that the prongs either side drop

into the slot on each armrest. Push down firmly.
Once the infant carrier is engaged you will hear a click.
Lower the infant carrier handle to the safety stop position. Please refer
to the user guide for the infant carrier.

WARNING

– Check that the attachment devices are correctly engaged

before use.

Removing the infant carrier

First engage the brake. To remove the
infant carrier, move the handle to the
carrying position.
Please refer to the user guide for the
infant carrier.
Pull up the release levers on each side

(dia 11d)

and lift the infant carrier out

of the sockets

(dia 11e)

The infant carrier is now ready for use.
Re-attach the armrest pads after use.

Removing the adaptors

To remove the adaptors from the child seat, pull the lever on the adaptors
away from the child seat while pulling down

(dia 11f)

. Repeat the

process for both adaptors.

IMPORTANT –

It may be necessary to remove the adaptors from the child seat when
installing it in your vehicle. If the adaptors are in contact with the vehicle
seat cushion, remove them.

Place the apron over the frame as
shown

(dia 10j)

On each side fold the ‘hook and loop
strap’ back onto itself, and tuck inside
the apron. Attach the remaining hook
strap on both sides of the apron to
the loop strip on each side of the seat
cover

(dia 10k)

. The loop strip on the

seat cover should be shared by the
hook straps on both the apron and
hood.

10j

10k

11a

11b

11c

11d

11e

11f

Fitting the hood

Place the hood in the correct position
(with the window at front of pushchair)
over the pushchair. Attach the hood
clip to each side of the pushchair
frame by locating the clips over the top
of the upper tube first, then pushing
until they click into place

(dia 10h)

Open the hood by pulling the front of
the canopy forwards engaging the
hood tensioners on each side to click
in place

(dia 10i)

Fasten the two press studs on the
hood to the press studs on the
underside of the calf support.

10h

10i