5
Operating Guide
Check carefully to ensure nothing blocked
the way before continue operating.
Remove it if found.
Overheat-System detects the action
exceeding the rated duty cycle and
prevents it from overheating.
Stop operating until error code is called off
automatically.
Block:
System detects a sudden resis-tance
like pinch during moving.
Error code
Overload:
System detects excessive weight
arrangement not following the rated capacity.
Information
Recommended disposition
Do not exceed the max. load of actuator.
●
Auto Stroke Learning
After installing the entire system correctly, you need to perform Auto Stroke Learning before you start using it.
Please follow the steps of button control or touch control.
- Key control (Take DP08 hand control as an example)
Step 1: Make sure that the power supply is connected and there are no obstacles in the moving path of
the lifting table.
Step 2: The hand control displays , press and buttons at the same time for 2 seconds,
flashes and starts automatic learning.
The lifting table will automatically move to the lowest position, move to the highest position,
and then return to the lowest position to complete automatic learning.
-
Touch control (Take DP07 hand control as an example)
Step 1: Make sure that the power supply is connected and there are no obstacles in the moving path of
the lifting table.
Step 2: The touch hand control displays , touch to enter learning mode.
Step 3: Touch and buttons at the same time until is displayed, flashes and starts
automatic learning. The lifting table will automatically move to the lowest position, move to the
highest position, and then return to the lowest position to complete automatic learning.
Remarks:
If the process of Auto stroke learning is interrupted, you need to perform auto learning again.
●
Calibrating the Height
When the height display is blinking, it means the height display needs to be recalibrated.
The possible causes are as follows:
-
Sudden power interruption during lifting movement
-
When the system detects an error in the table height. Please follow the steps below.
Step 1: Make sure there are no obstacles in the moving path of the lifting table
Step 2: While the height display is blinking, press button , and the lifting table will automatically
move to the lowest position to complete the calibration.
● Error Code Summary
For more information about the Hand control operation guide, please refer to the corresponding
product data sheet, which can be downloaded from the Moteck website.
