2-5
Status Monitor Program
602-13729-01 Rev B
Expedio Digital Electronic News Gathering Radio
2.4 Communications Settings
To begin communicating with the Expedio unit, the Communications Settings must be properly
configured.
•
In the
Comm Port
field, select the Comm Port to which the Serial Cable to the Expedio
unit is connected.
•
In the
Baud Rate
field, select the Baud Rate as configured on the Expedio unit. For more
information about configuring the baud rate, see the section of this manual regarding
hardware setup.
•
Optional
:
Check Status on Startup
automatically causes the Status Monitor Program to
begin monitoring the Expedio unit each time the program is launched.
Click
OK
to accept these communication settings.
Note:
The Communications Settings cannot be changed while Status Checking is started. To
change Communications Setting, ensure that Status Checking is stopped.
2.5 MPEG/COFDM Configurations
The behavior of the Expedio unit depends on its MPEG Configuration. The appropriate
configuration depends upon the system itself, so Expedio comes equipped with three preinstalled
configurations to choose from. Any of these can serve as the
default
configuration
, which is the
configuration that the Expedio will run whenever it is started or reset.
With administrative privileges, it is possible to modify the three preinstalled configurations. This
can only be done with the assistance of Moseley Technical Support personnel.
2.5.1 Switching
Configurations
1. In the Configuration Number field, enter the number of the desired configuration. For a
complete description of the factory installed configurations, see Default MPEG
Configuration Settings.
2. Click
Switch Config
.
3. A confirmation screen appears. If you are sure you want to change configurations, click
OK
.
