Sega GameGear Capacitor Replacement Kit
Page
19
of
26
V 1.6
Next you need to solder the replacement capacitor into place. Remember negative to negative and
positive to positive. We recommend the following strategy.
Picture Eleven: Lead soldering
Insert the leads and then bend them at a ninety degree angle. Then cut the leads down to the desired
length. Finally solder the leads into place.
Please continue replacing the capacitors as needed. Here are some very important points not to forget.
1)
Make sure you do not bridge any terminals
2)
Make sure the leads of the capacitors don’t touch each other.
3)
Don’t be afraid to bend the capacitors leads. You will have to flatten them anyways to get the
casing to close.
Once you are finished please reassembly your system and enjoy your working unit; however if
everything is not working correctly after it is back together please see our troubleshooting section at the
end of this guide.
