SECTION 2
12
Loading Paper
Figure 2-2
1.
Remove the outer packaging from the paper roll.
2.
Facing the front of the device, use the release latch on the top side to pull the paper tray cover slightly
to the right and lift up to open. Note: cover does not come completely off. Remove any empty paper
rolls.
3.
Place the roll of thermal paper into the paper tray such that the grid side of the paper is up and paper
roll edge faces to the left.
4.
Pull paper roll edge up and to the right to allow the paper tray cover to close with paper roll edge
extended out of the device. Use the release latch to pull the paper tray cover slightly to the right and
down until the cover latches in a locked position. You will hear a sharp click when the cover is latched
properly; this may require pressing down firmly on the top and bottom tabs of the paper tray cover
with your thumbs.
WARNING: Risk of injury to fingers in paper tray door or platen drive mechanisms.
NOTE: For proper performance of thermal writer, be certain to use Mortara recommended thermal
paper.
Summary of Contents for ELI 230
