Morso 5660 Standard Insert, Instructions For Installation And Use Manual

Page: 32 / 36

DK ENG
Comparison between firing with wood and oil:
type of wood (moisture content 20%) no. of cubic metres per 1000 l oil
Oak 7.0
Beech 7.0
Ash 7.2
Sycamore 7.5
Birch 8.0
elm 8.9
Common spruce 10.4
Silver fir 10.9
The stove door should normally be opened gently the first - cm, then you should wait until
the pressure has equalised before opening the door all the way. This technique will prevent
smoke from getting out, particularly when there is a poor draugt.
the stove door should never be opened when the stove is being fired vigorously.
Once the wood has burned out, it becomes glowing charcoall. If a good layer of embers has
already formed on top of a sufficient layer of ash, the stove can keep warm for a very long
time, not least due to the favourable qualities of the cast iron.
We would strongly recommend that you do not leave your stove alit at night.
It harms the environment and constitutes very poor use of the wood as the
gases in the wood do not ignite at the low temperature, but settle as soot
(unburned gases) in the chimney and stove. extreme conditions, such as
poor draught in the chimney, large quantities of wood or wet wood, may in
the worst-case scenario cause an explosive ignition.
When firing in the summer period, when there is minimal need for heat, the
combustion will be poor. the stove provides too much heat so the combu-
stion should be reduced. But always remember to make sure that there are
lasting flames until the wood becomes charcoal. If you want a weaker fire,
stoke up using less wood.
If you fire the stove using wet wood, a lot of the fuel’s thermal energy will be
spent forcing the water out of the wood, without releasing any heat to the
stove. this incomplete combustion results in a layer of soot being left in the
stove, pipe and chimney.