morse GCRS-40-40 T4F, Product Manual

Page: 11 / 34

311822 11
Hazards & Warnings
Electrical Shock Hazards
This generator produces dangerous electrical voltages
that can cause fatal electrical shock. Avoid contact
with bare wires, terminals, connections, etc. while the
unit is running. Make sure all appropriate covers,
guards, and barriers are in place before operating the
Generator.
● Do not assume that there is not power flow to the
terminals, connections, bare wires, etc. when the
generator is not running. The unit could be
connected to another power source that could
back feed through the generator wire leads.
Always test the wire leads for power before
working on the unit.
● The National Electrical Code (NEC) requires the
frame and external electrically conductive parts
of the generator to be connected to an approved
earth ground unless the generator is vehicle
mounted. See article 250.34 of the NEC handbook
if the generator is to be mounted in a portable
vehicle.
Fire Hazards
● For fire safety, the generator must be operated
and maintained properly. Operation must always
comply with applicable codes, standards, laws
and regulations. Adhere strictly to local, state, and
national electrical and building codes. Comply
with regulations of the Occupational Safety and
Health Administration (OSHA). Ensure the
generator and engine are operated in accordance
with the manufacturer’s instructions and
recommendations. Do not alter the construction
of the generator or engine or change controls
which might create an unsafe operating condition.
● Keep a fire extinguisher near the generator at all
times. Make sure the extinguisher is rated “ABC”
by the National Fire Protection Association. Keep
the extinguisher properly charged and be
informed on instructions for use.
Explosion Hazards
● Do not smoke around the generator. Wipe any fuel
or oil spills immediately. Make sure there are no
combustible materials near or on the generator
that can cause a FIRE or EXPLOSION. Keep the
area surrounding the generator clean and free
from debris.
DO NOT START OR STOP GENERATOR
WITH ANY CONNECTED ELECTRICAL
DEVICE TURNED ON. GENERATOR MUST
NOT BE STARTED OR STOPPED WITH
ANY TYPE OF ELECTRICAL LOAD ON
THE GENERATOR. LOAD GENERATOR
AFTER THE GENERATOR IS WARMED UP.
Warnings
● Operators must not tamper with engine governed
speed. High operating speeds are dangerous and
increase risk of personal injury or damage to
equipment. The generator supplies correct rated
frequency and voltage only when running at
proper governed speed. Incorrect frequency
and/or voltage can damage some connected
electrical loads.
● Electrical surges and spikes can cause serious
damage to your system and everything plugged
into it. Proper surge protectors should be used
between the receptacles and every electrical
system being used.
● Never weld to truck or trailer chassis, as this will
cause damage to many electrical or electronic
components grounded to vehicle chassis.