The Specialist In Drum Handling Equipment
Model 520-120
Vertical-Lift, 106”, AC Power Lift, Manual Tilt
Operator’s Manual for Morse Vertical-Lift Drum Pourer Model 520-120
Serial Number 249855 to ______
morsedrum.com
Copyright 2022 - Morse Mfg. Co., Inc.
Form OM520-120 (24985- ______)
(Updated 18 Feb, 2022)
4
Controls
The Morse Vertical-Lift Drum Pourer
is manually propelled and steered. The drum
lift is powered by a single phase 115V AC motor with a momentary switch, cord
and plug.
There are two functions for the operator to control (Figure 3.1).
1. LIFT and Lower Function for vertical positioning of the drum.
a. Plug the motor into a standard 115V power supply.
b. Turn the motor on by holding the momentary switch in the on position. The
drum will lift.
c. Release the momentary switch when the drum is at the desired height.
d. To lower the drum: With the motor off, push in the LOWER handle.
2. TILT Function to control the degree of rotation of the drum.
a. Turn the hand crank to turn the drum.
b. Before releasing your grip on the hand crank, pull out the crank stop pin to
block the hand crank from spinning freely.
c. If the drum handler is equipped with the MORStop Tilt-Brake, there is no
need to use the stop pin. Braking is immediate and self-actuating, without
additional steps by the operator.
Note: To add the MORStop Tilt-Brake to an existing drum handler, order part #
3900-P for a field installation kit.
WARNING
- Watch out for pinch points
Stay clear of moving parts. Operator should remain behind the
push handle during the lift operation.
Floor Lock
Floor lock handle is located on left side of push handle. Pulling floor lock handle toward operator until it locks in down position activates
the floor lock. When floor lock is activated it prevents unwanted free wheeling of unit. Floor conditions determine effectiveness of floor
lock. Operator should verify its holding action before depending on it to hold.
Drum Holder Assembly
MORCINCH
TM
Drum Holder assembly (“saddle”) is the component on Vertical-Lift Drum Pourer intended to hold drum. Carriage assembly
moves vertically along mast to position drum holder assembly at correct height to secure drum around it’s middle using cinch chain and
ratchet tightening system.
The MORCINCH
TM
Drum Holder accepts accessories to handle plastic drum, fiber drum, or a smaller diameter drum.
Figure 3.1
