The Specialist In Drum Handling Equipment
Model 410-125
Heavy-Duty Hydra-Lift, 72”, DC Power Lift, Manual Tilt
operator’s Manual for Morse Heavy-Duty Hydra-Lift Karrier Model 410-125
serial number 1210 to ____ (MMYY)
Copyright 2021 - Morse Mfg. Co., Inc.
Form OM410-125 (1210-____) (Updated 6 Jul, 2021)
3
Machine Description
The Model 410-125 Heavy-Duty Hydra-Lift Karrier will pour a drum
up to 72” (183 cm) high, measured from the floor to the lowest
point of a horizontal drum. It is designed to lift, transport, and
dispense a 55-gallon (210 liter) steel or fiber drum 22” to 23.5” (56
to 59.7 cm) in diameter.
The maximum full-drum capacity is 1200 Lb. (544 kg). The
capacity is derated to 600 Lb. (272 kg) for a half-full drum. The
half-full rating is based on the tilt mechanism’s capacity for
handling an unbalanced bottom-heavy drum.
options
A smaller diameter drum can be handled with the correct
•
size 55/30 Series Diameter Adapter installed (see
).
The adjustable Bracket Assembly (Kit # 4556-P) is
•
required
to handle a plastic drum without a top rim (see figure 2.1). The
Bracket Assembly is also recommended when handling a fiber
drum. You can also use the Bracket Assembly when handling
a rimmed drum.
To handle a 55-gallon (210 liter) plastic drum with suitable top
•
rim, you
must
install either the Bracket Assembly or the Top
Rim Clamp (Kit # 4560-P) (see figure 2.2). You can use the
Top Rim Clamp to handle a 55-gallon plastic, steel or fiber
drum with suitable top rim.
Controls
The Morse Heavy-Duty Hydra-Lift Karrier is manually propelled and steered.
The drum lift is powered by a 12V DC motor. There are two functions for
the operator to control (Figure 2.3):
1. LIFT and Lower Function to raise and lower the drum
Push and hold the valve handle in against the start switch.
•
Release the handle when the drum is at the desired height.
•
To lower the drum: Pull and hold the valve handle out away from the
•
start switch.
2. TILT Function to control the degree of rotation of the drum.
Pull down on one side of chain, rotating drum to angle required for
•
pouring.
The drum handler is equipped with the MORStop Tilt-Brake, there is
•
no need to hold tension on both sides of the chain loop. Braking is
immediate and self-actuating, without additional steps by the operator.
Figure 2.3
Figure 2.2
Plastic drum being lifted
with Kit # 4560-P Top
Rim Clamp Assembly
installed.
Figure 2.1
Plastic drum being lifted
with Kit # 4556-P Bracket
Assembly installed.