background image

2

Morrison Bros. Co.  -  Dubuque, IA  -  800-553-4840

610XB-0110 PP

rev. 08-31-15

!

11. If you want to adjust the cable length, or for any reason you need to remove the cable clamps, see Figure 1 

below before reattaching clamps.

12. With everything in the proper position and all screws and nuts tightened down, make sure Hose Retriever 

unit is stable. If so, you can now attach Hose Clamp and Fuel Hose. Swivels and a breakaway are 
recommended at all hose ends to prevent hose twisting and protect the hose from damage.

Maintenance

This unit should be inspected at least once per year.

WARNINGS

• 

For your safety, it is important to follow local, state, federal and/or OSHA rules that apply to working 

inside, above, or around the storage tank and piping area. Use all personal protective equipment required 
for working in the specifi c environment. 

Steps

1. Pull on the hose to expose the cable. While the cable is exposed inspect it for wear or damage. If excessive 

cable wear or cable damage is found, replace the cable.

2. Inspect the retriever head for signs of wear or damage. If excessive wear or damage is found, replace the 

head.

3. Inspect the hose clamp for signs of wear or damage. If excessive wear or damage is found, replace the 

damaged component.

4. Check for signs that the stability of the unit has been compromised such as, impact, deteriorating concrete 

around the base or anchor bolts, loose fasteners, rusted components, etc. If any of these signs are present, they 
should be repaired or the components replaced.

5. If painting the retriever head, use caution to insure that the paint does not get into an area that could restrict 

the swivel motion of the retriever head or the spinning of the pulley.

Failure to follow any or all of the warnings and instructions in this document could result in a hazardous 
liquid spill, which could result in property damage, environmental contamination, fi re, explosion, serious 
injury or death.

Figure 1

!

Reviews: